DIY Paracord Dog Tab Leash – Shark Jaw Knot

DIY Paracord Dog Tab Leash Shark Jaw Knot

This paracord dog tab leash was made using the shark jaw knot.

Supplies Needed:

  1. Scissors
  2. Paracord – You will need two pieces of paracord at 106 feet each.
  3. Lighter – To singe the ends of the paracord. Can also be used to finish and melt the ends to the main cords at the end of the paracord dog leash.
  4. Dog Leash Clip – You can use whatever you prefer as the dog leash clip. In my video I used a lobster clasp rated for a maximum weight of 40 pounds.
  5. Paracord Jig (Optional) – This is helpful for keeping your paracord tight when working. The one I used in this video can be found at https://amzn.to/2FnCqvf. There is a smaller paracord jig also https://amzn.to/2Dk5AbL.

*Please note that the above links are affiliate links and I earn affiliate commission through these links. Going through these links does not cost you any extra money.*

Leave a Reply

Your email address will not be published. Required fields are marked *